| Cylinder type sensing head size |
M18 |
| Type |
Shielded |
| Sensing method |
Inductive type |
| Sensing distance |
5mm -10% to +10% |
| Setting distance |
0 to 4 mm |
| Differential distance |
10% Max. of sensing distance |
| Sensing object |
Ferrous metal (Sensitivity lowers with non-ferrous metals.) |
| Standard sensing object |
Iron 18*18*1mm |
| Response frequency |
DC: 0.6 kHz (average) |
| Power supply voltage |
12 to 24 VDC ripple(p-p) :10% Max. |
| Operating voltage range |
10 to 40 VDC |
| Current consumption |
13 mA Max. |
| Control output (Output type) |
PNP voltage-current output |
| Control outpu (Switching capacity) |
0 to 200mA |
| Control outpu (Residual voltage) |
2 V Max. （under load current with cable length of 2m） |
| Indicator |
Operation indicator(red) |
| Operation mode |
NO |
| Protective circuit |
Surge suppressor
Output short-cut protection
Power supply reverse polarity protection |
| Ambient temperature |
Operating: -40 to 85 ℃
Storage: -40 to 85℃
(with no icing or condensation) |
| Ambient humidity |
Operating: 35 to 95 %RH
Storage: 35 to 95 %RH
(with no condensation) |
| Temperature influence |
+/- 10% Max. of sensing distance in temperature range of -25 to +70 CEL
+/- 15% Max. of sensing distance in temperature range of -40 to +85 CEL
(As the basis for sensing distance of 23CEL) |
| Voltage influence |
+/- 1% Max. of sensing distance in rated voltage range +/- 15%. (As the basis for sensing distance at standard power voltage) |
| Insulation resistance |
50 M OHM Min. at 500VDC between charged parts and the case |
| Dielectric strength |
1000 VAC 50/60 Hz for 1 minute between charged parts and the case |
| Vibration resistance |
10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions |
| Shock resistance |
1000m/s2 for 10 times each in X, Y, and Z directions |
| Degree of protection |
IEC60529: IP67 |
| Applicable standard (EC Directive (Low Voltage Directive) ) |
EN60947-1
EN60947-5-2 |
| Applicable standard (EC Directive (EMC)) |
EMI: EN60947-5-2
Emission Enclosure: CISPR11 Group 1 class A
EMS: EN60947-5-2
Immunity ESD: IEC61000-4-2
Immunity RF-interference: IEC61000-4-3
Immunity Conducted Disturbance: IEC61000-4-6
Immunity Burst: IEC61000-4-4
CE marking: Equipped |
| Applicable standard (CCC mark) |
Not equipped |
| Connection method |
M12 connector models |
| Weight (Packed state) |
approx. 40 g |
| Material (case) |
Brass nickel plating |
| Material (sensing surface) |
PBT |
| Material (clamping nuts) |
Brass nickel plating |
| Material (toothed washer) |
Iron zinc plating |
| Accessories |
Instruction manual |
