Ta strona wykorzystuje pliki cookies. Korzystając ze strony, zgadzasz się na ich użycie. OK Polityka Prywatności Zaakceptuj i zamknij X

Bluetooth Shield for Arduino

02-08-2012, 3:29
Aukcja w czasie sprawdzania była zakończona.
Cena kup teraz: 102 zł     
Użytkownik arduinosolutions
numer aukcji: 2427619959
Miejscowość Goczałkowice-Zdrój
Wyświetleń: 180   
Koniec: 17-07-2012 13:43:01

Dodatkowe informacje:
Stan: Nowy
info Niektóre dane mogą być zasłonięte. Żeby je odsłonić przepisz token po prawej stronie. captcha

 

logo

 

 

 

Bluetooth Shield is an easy to use module compatible with existing Arduino/Seeedstudio, based on Serial port Bluetooth module, designed for transparent wireless serial connection setup. You can choose XDUINO's Digital PIN D0->D7 as Software UART to communicate with Bluetooth Shield(and D0,D1 also is Hardware UART). It has two Twig connectors(one is Digital,the other is IIC/Anolog) for you to install twigs.

Serial port Bluetooth module is fully qualified Bluetooth V2.0+EDR(Enhanced Data Rate) 3Mbps Modulation with complete 2.4GHz radio transceiver and baseband. It uses CSR Bluecore 04-External single chip Bluetooth system with CMOS technology and with AFH(Adaptive Frequency Hopping Feature). Hope it will simplify your overall design/development cycle.



Hardware Features

  • Seeedduino/Arduino compatible.
  • Typical -80dBm sensitivity.
  • Up to +4dBm RF transmit power.
  • Fully Qualified Bluetooth V2.0+EDR 3Mbps Modulation.
  • Low Power Operation.
  • PIO control.
  • UART interface with programmable baud rate.
  • Integrated PCB antenna.


Software Features

  • Default Baud rate: 38400, Data bits:8, Stop bit:1,Parity:No parity.
  • Supported baud rate: 9600,19200,38400,57600,11[zasłonięte],230400,460800.
  • Status instruction port PIO1: low-disconnected, high-connected(3V3); Can be read from ANALOG PIN 2 (A2).
  • PIO10 is connected to red led, PIO11 is connected to green led. When master and slave are paired, red and green led blinks 1time / 2s in interval, while disconnected only green led blinks 2 times/ s.
  • Auto-connect the last device on power as default.
  • Permit matched device connect by default.
  • Default PINCODE:”0000”.
  • Auto-reconnect in 30 min when disconnected as a result of beyond the range of connection.

Application Ideas

  • As a Wireless Serial Port for Arduino / Seeeduino and other MCUs
  • As a Bluetooth Serial Port for PC when connected with UartSBee


Documents

Please visit  wiki page for more info about this product.


 

 

Na przedmioty wystawiam paragon lub fakturę VAT.
tel. 663 [zasłonięte] 362 od godz.10 do 18

Kupując na kilku moich aukcjach za przesyłkę płacisz tylko raz.

 

 

Zapraszam do obejrzenia moich innych aukcji.